What is a down-the-hole drilling rig

A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud). The DTH hammer is one of the fastest ways to drill hard rock. The system is thought to have been invented independently by Stenuick. Origin of the nameDTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes. . In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the flui. . A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the quarry face in order to place the drill hole in. [pdf]

What to do if the rock drill gets hot

First, safely remove the bit from the drill—use a cloth or gloves to avoid direct contact with the overheated metal. Inspect the bit for any visible damage such as discoloration or warping. If the bit appears to be damaged, it’s best to replace it.. First, safely remove the bit from the drill—use a cloth or gloves to avoid direct contact with the overheated metal. Inspect the bit for any visible damage such as discoloration or warping. If the bit appears to be damaged, it’s best to replace it.. Stop Using the Drill: As soon as you notice the drill overheating, stop using it immediately. Continuing to use it can cause damage to the tool and increase safety risks. Disconnect Power: Unplug the drill from the power supply.. Overheating in drills is more serious than it sounds, and you should know the correct ways to fix your tool fast. The easiest and most common ways to cool down the drill include changing the drill bit and lubricating it. It is likely time to change your drill bit when it gets full. [pdf]

The screw air compressor is full of air pressure and keeps pumping What s the problem

Check the fuse, motor, and thermal relay and other equipment. Ensure that these devices are in a normal operating state. If there are problems or hidden dangers, relevant measures need to be taken to replace these devices in time. Check the pressure and temperature sensor and start button.. Check the fuse, motor, and thermal relay and other equipment. Ensure that these devices are in a normal operating state. If there are problems or hidden dangers, relevant measures need to be taken to replace these devices in time. Check the pressure and temperature sensor and start button.. A screw compressor can run loaded ('pumping air') or unloaded ('idle'). The inlet/loading valve opens and closes according to air demand. The inlet valve is controlled by a solenoid valve that supplies control air to the inlet/loading valve. Check solenoid valve coil and solenoid valve operation.. The main causes involve improper slide valve positioning, component wear, insufficient voltage, pipeline vibrations, and inadequate oil levels.. The inlet valve is controlled by a solenoid valve that supplies control air to the inlet/loading valve. Check solenoid valve coil and solenoid valve operation. First, check that there isn’t a very high air demand, or air leak somewhere. Check differential pressure over oil separator. [pdf]