Key tasks include changing oil and filters, cleaning air filters and cooling systems, inspecting motors and wiring, and ensuring proper operation of key components. Daily maintenance should focus on cleaning, monitoring performance, and adjusting load..
Key tasks include changing oil and filters, cleaning air filters and cooling systems, inspecting motors and wiring, and ensuring proper operation of key components. Daily maintenance should focus on cleaning, monitoring performance, and adjusting load..
Mount a thermometer in the compressor room. Increase ventilation if room temperature exceeds operating limits. Inspect and remove/vacuum loose dust from inlet filters. Frequency depends on ambient dust load. Inspect and vacuum ambient side of coolers. Frequency depends on ambient dust load.
[pdf] 
Your drill has many grease points that prevent early wear and allow your machine to run smoothly. Regular greasing is important. .
The feed rail chain on your WORD Rock Drill can become loose periodically. The natural movement of the machine during drilling leads to wear within the primary sprocket of the feed. .
No job site is clean, so it is almost impossible to prevent your quick connects from getting dirty even when they are hooked up. Although they pretty much stay dirty, it’s important to clean the quick connects when re-attaching them to your machine. With the. .
During your down time it is important to make sure your line oiler is refilled with rock drill oil. When drilling, the oil level in your line oiler should. .
The extension clamp plates are protective plates located on your feed rail. These plates serve as a buffer between the steel of your feed rail and the steel of your feed rail extension piece.. Appropriate care matters: Daily drill bit care improves efficiency, safety, and extends your equipment’s lifespan on any terrain. Inspect and clean regularly: Routine checks and cleaning prevent wear, overheating, and unplanned downtime.
[pdf] Under normal conditions, a pressure switch or transducer controls the air pressure in a compressor. When the pressure switch reaches its cut-out set pressure, the compressor stops compressing air (unload) until it reaches the cut-in set pressure and starts compressing air again (load). The compressor cannot. .
A pressure relief valve in an air compressor opens when excessive pressure builds up inside the compressor, or the valve fails. .
A pressure relief valve may not come with a pressure vessel purchased separately from the air compressor. It is crucial to add a pressure relief valve to ensure safe operation. There are.
[pdf] 
