Before diving into whether or not you should invest in a dual-rod machine, you need to know a little bit about the technology and its advantages for drilling in rock. “Dual-rod systems use two independently controlled drill rods— one within the other — during operation,” explained Michael. “While drilling out the pilot. .
One of the first factors to consider before choosing a dual-rod machine is the type of rock you’re working in. “Dual-rod drills are efficient in light- and. .
For most utility HDD work, small jobsites and the ability to quickly set up and tear down are essential to a crew’s operating efficiency. “Dual-rod machines can often be transported on. .
As you can see, the decision to add a dual-rod machine if more than 50% of your work is in rock, or to add a single-rod machine if less than 25% of your work is in rock, is pretty straightforward. However, if you fall someplace in the middle, then you have a lot to. .
Of course, how long a bore takes can often depend on the operator’s skills running the drill. Michael said the operator’s capabilities on the drill is another critical factor to consider when deciding between a single-rod and a dual-rod machine..
[pdf] 
The longer your feed rail, the more important the addition of the energy chain becomes to the overall effectiveness of your machine. We offer a range of feed rail options from 6′ to 24′ for our Skid Steer and Excavator attachments depending on your specific project requirements. The addition of an energy. .
A common addition whenever a unit is equipped with a Doofor drilling motor, hydraulic clamp, or hydraulic breaker; this accessory comes in handy for routine maintenance of any. .
Making this accessory addition to your excavator or skid steer drilling attachment can really boost efficiency on the job site when dealing with. .
An easy add-on to any excavator attachment purchase, the addition of angle indication to your remote will provide you with a digital readout of your drill positioning. This feature is particularly beneficial when you are on a job that requires specific. .
A very helpful accessory whenever you are operating with casing, the addition of a hydraulic clamp and clamp breaker to your machine saves your.
[pdf] This robust head cuts the hard rock with single disc cutters. The cutters are located on the cutterhead in a geometric pattern that allows the disc to create a kerf (crush zone). The thrust at these kerfs creates fractures and cracks in the rock face, which ultimately form chips of rock. .
This will allow you to steer the machine and ensure accuracy of line and grade. The forward shield can be articulated in any direction necessary to allow accurate line and grade when. .
In the case of longer bores or difficult ground conditions, it may be necessary to go to the front of the cutterhead. In the case of longer bores or those in hard rock, the cutters will need to be changed. Whether or not they need to be changed is highly dependent on.
[pdf] 