The Boyles C5/C5C surface core drilling rig is compact, yet powerful. Its compact design makes it easy to position and transport, even by helicopter. During helicopter transport, the rig is broken down into six main modules and each module is equipped with lifting points to ensure safe and effective transport. Boyles. .
The Christensen range of surface core drilling rigs has, over many years, established itself a reputation for reliability and ease of use. Many Christensen rigs are. .
For underground core drilling exploration tasks, Epiroc offers the well-established and trusted Diamec range of machines. Diamec rigs are available in a wide variety.
[pdf] 1. Prepare the rock-drilling cavern, the specifications of which can be determined according to the method of drilling. Generally speaking, the height of the cavity is 2.6-2.8 meters when drilling a horizontal hole with a down-the-hole drill. When drilling upward, downward, or inclined holes, the width of the cavity is. .
1. When starting to work, carefully check whether the gas and water pipelines are firmly connected. Check for air leaks and water leaks. 2. Check whether the lubricator has been. .
When opening the hole, start the motor first, and pull the push handle of the manipulator after the transfer is normal. Make it get proper.
[pdf] 
Before diving into whether or not you should invest in a dual-rod machine, you need to know a little bit about the technology and its advantages for drilling in rock. “Dual-rod systems use two independently controlled drill rods— one within the other — during operation,” explained Michael. “While drilling out the pilot. .
One of the first factors to consider before choosing a dual-rod machine is the type of rock you’re working in. “Dual-rod drills are efficient in light- and. .
For most utility HDD work, small jobsites and the ability to quickly set up and tear down are essential to a crew’s operating efficiency. “Dual-rod machines can often be transported on. .
As you can see, the decision to add a dual-rod machine if more than 50% of your work is in rock, or to add a single-rod machine if less than 25% of your work is in rock, is pretty straightforward. However, if you fall someplace in the middle, then you have a lot to. .
Of course, how long a bore takes can often depend on the operator’s skills running the drill. Michael said the operator’s capabilities on the drill is another critical factor to consider when deciding between a single-rod and a dual-rod machine..
[pdf] 
