On today’s market, you have a choice of two main types of industrial rotary compressor – vane and screw. Although both are designed to produce the same output, they differ considerably in terms of energy efficiency. Here, we give you the low down. .
How they work – A rotary-vane compressorcomprises a rotor, with slots along its sides which house individual sliding vanes. This assembly is offset within a cylinder, or ‘stator’, and rotates on white-metal bushes. As the rotor turns on its axis, the vanes. .
Vane compressors typically run at lower speeds than relatively leaky screw machines. For example, Mattei’s fixed-speed Maximaoperates at 1,000rpm, versus the average screw compressor’s 3,000rpm or higher. Rotary-vane machines also have. .
How they work– A screw compressor has two parallel rotors which intersect along their sides. Replaceable roller bearings fitted into a stator maintain the rotors’ minimum clearance. During rotation, the intermeshing rotors compress the air. Their efficiency–.
[pdf] 
A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud)..
A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud)..
In down-the-hole drilling a drill rod is fitted with a hammer at its lower end. The hammer, which is mounted on the drill bit, is activated through the addition of compressed air and driven into the ground – simultaneously rotating and impacting..
Down-the-Hole (DTH) drilling is a technique used to create deep, precise holes in hard rock and challenging ground conditions. In this method, the hammer and drill bit are placed at the bottom of the drill string, directly engaging with the rock.
[pdf] 
The pump is responsible for compressing air. It may operate on a reciprocating mechanism (using pistons and cylinders) or a rotary mechanism (using screws or vanes). The pump draws in atmospheric air, compresses it, and sends it into the storage tank..
The pump is responsible for compressing air. It may operate on a reciprocating mechanism (using pistons and cylinders) or a rotary mechanism (using screws or vanes). The pump draws in atmospheric air, compresses it, and sends it into the storage tank..
The pump creates a pressure gradient (higher pressure at the outlet than at the inlet) to force air movement. A flexible diaphragm moves back and forth, changing the volume of an enclosed chamber. On the backstroke, the diaphragm pulls air into the chamber..
The working principle of this device relies on the conversion of electrical energy into mechanical energy. The electric motor present in the compressor provides power to the system, which drives the piston in a reciprocating manner..
This is achieved by using an electric motor, diesel, or gasoline engine to forcefully draw in ambient air and reduce its volume by compressing it, which increases the air’s pressure. Once compressed, the air is stored in a tank until needed.
[pdf]