The gasoline rock drilling machine is a portable rock drilling tool consisting of a small petrol engine, an air compressor, and a rock drill. During operation, rock powder is blown away by the compressed air produced by the machine itself. It can be used with a support frame. This gasoline rock drill is portable,. .
About Oil Circuit Failure The fuel used in the gasoline rock drill machine is the No.70 and the No.15 gasoline engine lubricating oil, which should be matched strictly according to. .
At YG Machinery, we have sold thousands of gasoline rock drills. Every customer reported that the quality of the machine is good and the price is more accurate than that of our peers..
[pdf] 
First, safely remove the bit from the drill—use a cloth or gloves to avoid direct contact with the overheated metal. Inspect the bit for any visible damage such as discoloration or warping. If the bit appears to be damaged, it’s best to replace it..
First, safely remove the bit from the drill—use a cloth or gloves to avoid direct contact with the overheated metal. Inspect the bit for any visible damage such as discoloration or warping. If the bit appears to be damaged, it’s best to replace it..
Stop Using the Drill: As soon as you notice the drill overheating, stop using it immediately. Continuing to use it can cause damage to the tool and increase safety risks. Disconnect Power: Unplug the drill from the power supply..
Overheating in drills is more serious than it sounds, and you should know the correct ways to fix your tool fast. The easiest and most common ways to cool down the drill include changing the drill bit and lubricating it. It is likely time to change your drill bit when it gets full.
[pdf] 
A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud). The DTH hammer is one of the fastest ways to drill hard rock. The system is thought to have been invented independently by Stenuick. Origin of the nameDTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes downwards in surface-drilling applications, its name originated from the fact that the percussion mechanis. .
In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the flui. .
A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the quarry face in order to place the drill hole in.
[pdf] 