with Blast Hole Coupling and High Speed Water Swivel .
The chuck is accurately machined to assure perfect alignment. The jaws are held by two large, Allen set screws with countersunk heads in chuck body to make it impossible for them to catch the operator’s clothing while rotating. Successive pairs of. .
Exploded view showing method of jacking rear end plate out of motor housing for changing rotor blades .
The reversible air motor greatly speeds blast hole drilling by allowing rapid unscrewing of rod joints, after breaking joint with a wrench, and allowing for rapidly moving the chuck or blast hole coupling into drilling position. High bit speeds available where. .
The motor consists of a cylinder in which a rotor is mounted eccentrically, six slots in the rotor hold six laminated, phenolic blades which move in and out against the cylinder wall as the rotor revolves. These blades and the rotor are the only rotating parts. Ball bearings,.
[pdf] 
DTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes downwards in surface-drilling applications, its name originated from the fact that the percussion mechanism followed the bit down into the hole. Applications were later found for the DTH method underground, where the direction of drilling is generally upwards instead of do. OverviewA down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated. .
In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the flui. .
A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the quarry face in order to place the drill hole in.
[pdf] 
DTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes downwards in surface-drilling applications, its name originated from the fact that the percussion mechanism followed the bit down into the hole. Applications were later found for the DTH method. .
A down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a. .
A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the. .
In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the fluid (air, water or drilling mud) used to. .
DTH products can be used in the following applications:• Mining- drill and blast holes in open pit mining, where the drill operator will drill several holes, then. Down the Hole Hammer (DTH) is a versatile horizontal drilling method, capable of tunneling through the toughest soil types and rock formations. DTH can break through cobbles, boulders, and even solid rock — which allows our team to complete installations in otherwise impenetrable ground conditions.
[pdf] 