Your drill has many grease points that prevent early wear and allow your machine to run smoothly. Regular greasing is important. .
The feed rail chain on your WORD Rock Drill can become loose periodically. The natural movement of the machine during drilling leads to wear within the primary sprocket of the feed. .
No job site is clean, so it is almost impossible to prevent your quick connects from getting dirty even when they are hooked up. Although they pretty much stay dirty, it’s important to clean the quick connects when re-attaching them to your machine. With the. .
During your down time it is important to make sure your line oiler is refilled with rock drill oil. When drilling, the oil level in your line oiler should. .
The extension clamp plates are protective plates located on your feed rail. These plates serve as a buffer between the steel of your feed rail and the steel of your feed rail extension piece.. Appropriate care matters: Daily drill bit care improves efficiency, safety, and extends your equipment’s lifespan on any terrain. Inspect and clean regularly: Routine checks and cleaning prevent wear, overheating, and unplanned downtime.
[pdf] 
A drifter drill, sometimes called a rock drill, is a tool used in mining and civil engineering to drill into rock. Rock drills are used for making holes for placing dynamite or other explosives in rock blasting, and holes for plug and feather quarrying. While a rock drill may be as simple as a specialized. .
The simplest form of rock drill consists of a long chisel or drill steel that was struck with a . , who worked unsuccessfully as a silver miner in the early 1860s before taking up journalism,. .
Rock is hard and would quickly wear out a plain steel drill bit. Typically the drill is tipped with an insert of a much harder material that can be replaced as it wears away, such as. .
In reciprocating power drills, the drilling cylinder is mounted on a feed-screw, such that as the hole is drilled and the drilling point recedes from the rock face, the drill-bit continues to move into it, while the anchor point (on the tripod or column) remains in place.. .
In 1849, J. J. Couch, an American inventor from Philadelphia, received the first patent for a rock drill. It featured a drill rod which passed through a hollow piston and was thrown against the rock.In 1851, James Fowle received a patent for a rock drill.
[pdf] 
Before diving into whether or not you should invest in a dual-rod machine, you need to know a little bit about the technology and its advantages for drilling in rock. “Dual-rod systems use two independently controlled drill rods— one within the other — during operation,” explained Michael. “While drilling out the pilot. .
One of the first factors to consider before choosing a dual-rod machine is the type of rock you’re working in. “Dual-rod drills are efficient in light- and. .
For most utility HDD work, small jobsites and the ability to quickly set up and tear down are essential to a crew’s operating efficiency. “Dual-rod machines can often be transported on. .
As you can see, the decision to add a dual-rod machine if more than 50% of your work is in rock, or to add a single-rod machine if less than 25% of your work is in rock, is pretty straightforward. However, if you fall someplace in the middle, then you have a lot to. .
Of course, how long a bore takes can often depend on the operator’s skills running the drill. Michael said the operator’s capabilities on the drill is another critical factor to consider when deciding between a single-rod and a dual-rod machine..
[pdf]