with Blast Hole Coupling and High Speed Water Swivel .
The chuck is accurately machined to assure perfect alignment. The jaws are held by two large, Allen set screws with countersunk heads in chuck body to make it impossible for them to catch the operator’s clothing while rotating. Successive pairs of. .
Exploded view showing method of jacking rear end plate out of motor housing for changing rotor blades .
The reversible air motor greatly speeds blast hole drilling by allowing rapid unscrewing of rod joints, after breaking joint with a wrench, and allowing for rapidly moving the chuck or blast hole coupling into drilling position. High bit speeds available where. .
The motor consists of a cylinder in which a rotor is mounted eccentrically, six slots in the rotor hold six laminated, phenolic blades which move in and out against the cylinder wall as the rotor revolves. These blades and the rotor are the only rotating parts. Ball bearings,.
[pdf] Years ago I was captivated by an artisan working on jewelry at a Renaissance festival. She was creating a necklace using Tiger’s Eye and drilling out a hole with a hand-powered drill. I was just as impressed with the skill needed to work the tool as much as I was with the necklace being made. Many of today’s. .
There are some steps that will be the same no matter what tool is used when drilling holes in rock. I want to list them here so that they will not be repeated. Your eyes will thank me later. .
Rotary tools, like the Dremel, are not the only types of tools that can be used to make holes in small rocks. From ancient hand-powered.
[pdf] 
Before diving into whether or not you should invest in a dual-rod machine, you need to know a little bit about the technology and its advantages for drilling in rock. “Dual-rod systems use two independently controlled drill rods— one within the other — during operation,” explained Michael. “While drilling out the pilot. .
One of the first factors to consider before choosing a dual-rod machine is the type of rock you’re working in. “Dual-rod drills are efficient in light- and. .
For most utility HDD work, small jobsites and the ability to quickly set up and tear down are essential to a crew’s operating efficiency. “Dual-rod machines can often be transported on. .
As you can see, the decision to add a dual-rod machine if more than 50% of your work is in rock, or to add a single-rod machine if less than 25% of your work is in rock, is pretty straightforward. However, if you fall someplace in the middle, then you have a lot to. .
Of course, how long a bore takes can often depend on the operator’s skills running the drill. Michael said the operator’s capabilities on the drill is another critical factor to consider when deciding between a single-rod and a dual-rod machine..
[pdf] 
