How does a screw air compressor work?

Screw air compressor is divided into air cooling type and water cooling type, through the fan or water forcing cooling. Air cooling system consists of cooling fan, oil coolers and air cooler. The cooled air is pumped into the fan; go through oil cooler and air cooler, and at the same time, cool and compressing lubricating oil and air.

How to check if a compressor is working properly?

2、 Press the "start" button, the compressor can be work according to the set mode. At this time, observe whether normal of the display panel, pressure temperature, or abnormal sound, oil leakage. If there is abnormal, stop and check immediately. 3、 When press the "stop" button, the machine will stop after finishing unloading. It is normal

How to install air compressor?

The ground is best to be smooth cement floor. The air compressor base should be placed at 0.5/1000 (mm). And there should be grooves around and on the platform, and then the oil and repairing or washing the ground. The size of the groove is decided by the user. 3. Make sure the bottom of the compressor is placed evenly on the platform, which can

Does oil-injection screw compressor need lubricating oil?

Lubricating oil has a decisive influence to oil-injection screw compressor. It will result in serious damage to the compressor if it is used improperly or mistakenly. So please follow the regulations below. 1、 Please use the specific compressor oil. 2.1、Oil should comply with the requirements.

How to stop air compressor after unload?

Tighten the valve after make sure there is no condensed water. And then open the valve of the supply air. 2、 Start: switch on the power, and click the "ON (I)" on the panel, then the compressor start working. 3、 Stop: click "OFF (O)" on the panel, air compressor will automatically stop after unload for some times.

How do I Reset my compressor?

When compressor is set as master ( No.1 ) in block status ,press this button to start the compressor and activate block mode function at the same time. When cursor is at any page icon, press this button to execute the corresponding function. When the controller is at alarm and stop status, press this button for 5s to reset.