How to install a screw air compressor?

The installation of a screw air compressor can be divided into four aspects: environmental requirements, ground placement requirements, piping installation, and electrical safety considerations. 1. The air compressor should be installed in a surrounding environment that is cool, has low humidity, and is relatively dust-free.

How should a compressor flange be supported in a pipe hanger?

Suction and discharge lines should be supported in pipe hangers so that the lines won’t move if disconnected from the compressor. The Table on the back cover gives maximum allowable flange loadings for various size compressors.

How do you attach a screw compressor to a skid?

Use I beams in the skid where the screw compressor will be attached to the sys-tem base. The I beams should run parallel to the package feet and support the feet for their full length. The compressor unit feet should be continuously welded to the system base at all points of contact.

Can a screw compressor convert shaft power into gas compression?

However, it must be recognized that screw compressors are capable of converting large quantities of shaft power into gas compression in a relatively small space and that the installation of any high-speed, high-power equipment should not be approached casually.

How rigid should a screw compressor be?

The attachment of an engine or turbine base to a screw compressor must be of suficient rigidity to maintain coupling alignment specifications at the compres-sor. For Frick compressors this is normally within .004 inch TIR radial and axial.

Can a Frick® screw compressor be installed on a steel system base?

When a Frick® screw compressor package is to be installed in a customer-pack-aged refrigeration system, it is common to mount the compressor unit directly onto a steel system base. In these cases the design of the system base and the mounting of the system base to the customers foundation are very important factors in minimizing vibra-tion.