Air compressor overheating is the #1 cause of unexpected shutdowns during operation. Temperature sensors inside the air compressor monitor air intake and discharge temperatures as well as oil temperatures. In most industrial compressed air systems, the temperature sensor is wired to a thermal cutoff. .
Air compression generates a lot of excess heat — in fact, about 80% of the energy that is put into the compressor is lost to heat. Known as the. .
How can you tell if your air compressor is overheating? If the air compressor is running hot, you will probably notice that it is hotter than normal. .
Can you perform your own compressor repairs? It depends on the type of compressor and the capabilities of your in-house maintenance. .
Fortunately, air compressor overheating can almost always be avoided with proper maintenance and care. It is important to pay attention to the signs of overheating and fix them.
[pdf] 
A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud). The DTH hammer is one of the fastest ways to drill. .
DTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes downwards in surface-drilling. .
A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the. .
In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the fluid (air, water or drilling mud) used to. .
DTH products can be used in the following applications:• Mining- drill and blast holes in open pit mining, where the drill operator will drill several holes, then.
[pdf] 