Oil-free screw air compressors ZR & ZT (VSD) Our oil-free rotary screw and tooth compressors are designed to have the lowest lifecycle cost and deliver the highest quality air for industry standards. ZR & ZT compressors are used in industries that require high compressed air quality standards such as Food &. .
Certified oil-free air Class 0 range of compressors, ISO 8573-1 class, you are sure to be working with zero risk of contamination,. .
The components of our ZR/ZT oil-free rotary screw air compressor range have been carefully designed in-house. This reduces losses and. .
Premium VSD+ Our VSD+ compressors are the premium products of the oil-free rotary screw and tooth compressors. We have created the ZR/ZT VSD+ ranges for those who are.
[pdf] 
Before diving into whether or not you should invest in a dual-rod machine, you need to know a little bit about the technology and its advantages for drilling in rock. “Dual-rod systems use two independently controlled drill rods— one within the other — during operation,” explained Michael. “While drilling out the pilot. .
One of the first factors to consider before choosing a dual-rod machine is the type of rock you’re working in. “Dual-rod drills are efficient in light- and. .
For most utility HDD work, small jobsites and the ability to quickly set up and tear down are essential to a crew’s operating efficiency. “Dual-rod machines can often be transported on. .
As you can see, the decision to add a dual-rod machine if more than 50% of your work is in rock, or to add a single-rod machine if less than 25% of your work is in rock, is pretty straightforward. However, if you fall someplace in the middle, then you have a lot to. .
Of course, how long a bore takes can often depend on the operator’s skills running the drill. Michael said the operator’s capabilities on the drill is another critical factor to consider when deciding between a single-rod and a dual-rod machine..
[pdf] This robust head cuts the hard rock with single disc cutters. The cutters are located on the cutterhead in a geometric pattern that allows the disc to create a kerf (crush zone). The thrust at these kerfs creates fractures and cracks in the rock face, which ultimately form chips of rock. .
This will allow you to steer the machine and ensure accuracy of line and grade. The forward shield can be articulated in any direction necessary to allow accurate line and grade when. .
In the case of longer bores or difficult ground conditions, it may be necessary to go to the front of the cutterhead. In the case of longer bores or those in hard rock, the cutters will need to be changed. Whether or not they need to be changed is highly dependent on.
[pdf] 
